Deployment Guide
Figure 16. Edit Client Network Settings
Steps
1. Conrm that the Netmask or Prex Length and VLAN Tag elds display the correct netmask or prex length and VLAN ID for
the client network. Modify these elds if necessary.
2. In the Virtual IP Addresses table, dene additional client VIPs for the cluster. To add a VIP, click Add, type the IP address in the
dialog box, and then click OK.
• Minimum requirement – One client VIP for each cluster
• Flat network recommendation – One client VIP for each cluster
• Routed network recommendation – One client VIP for each FS8600 client network port
3. In the Controller IP Addresses table, dene an IP address for each controller in the cluster.
a. Select the controller in the table, then click Edit Settings.
b. In the IP Address eld, type an IP address for the controller.
c. Click OK.
4. Click Next. An Add FluidFS Cluster progress page opens while the cluster is being created.
NOTE: The cluster creation process takes about 10 minutes.
• When the process is complete, if you congured a default gateway for the FluidFS cluster using the CLI before running the
Add FluidFS Cluster wizard, the Set Support User Password page opens.
• When the process is complete, if you have not congured a default gateway for the FluidFS cluster, the Congure Default
Gateway page opens. See Congure the Default Gateway.
Congure the Default Gateway
Specify an IP address for the default route for the cluster.
About this task
Use this page of the File System tab to congure the default gateway address of the FluidFS cluster.
Figure 17. Congure Default Gateway Page
Congure the FluidFS Cluster
31