User manual

Removing and Replacing Parts 4-25
To install a Slot 2 SEC cartridge/heat sink assembly, press the cartridge firmly
into its connector until it is firmly seated. You must use up to 25 pounds of
force to fully seat the cartridge in its connector. Place the top bracket on top of
the cartridge. Install the four large thumbscrews through the top bracket holes
and through the holes in the guide bracket assembly to secure the heat sink to
the system board.
NOTE: Both processor slots must be populated with either a Pentium II Xeon
processor or a Dell terminator card. If a slot is not occupied, or if a non-Dell ter-
minator card is installed, the system will not power on.
If necessary, change the processor speed jumper setting (see Figure 4-17 to
locate system board jumpers).
The processor speed jumper should be set for the installed processor’s rated
internal speed. For example, for a 400-MHz Intel Pentium II Xeon processor, a
jumper plug should be installed on the pins labeled “400MHZ.” (See Chapter 1,
“System Board Jumpers,” for more information on the jumpers.) The processor
speed jumper setting must not exceed the slowest internal speed of either
processor.