Service Manual
Table Of Contents
- OptiPlex 3000 Thin Client Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 3000 Thin Client
- Side cover
- Speaker
- Solid-state drive assembly
- Memory
- WLAN card
- Optional modules
- Removing the optional Type-C module
- Installing the optional Type-C module
- Removing the optional HDMI module
- Installing the optional HDMI module
- Removing the optional Serial module
- Installing the optional Serial module
- Removing the optional PS/2 keyboard/mouse module
- Installing the optional PS/2 keyboard/mouse module
- Coin-cell battery
- Heat sink
- Antenna Assembly
- SMA Antenna Assembly
- System board
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Loosen the two captive screws that secure the solid-state drive heat sink to the system.
2. Lift and remove the solid-state drive heat-sink from the system.
3. Remove the screw (M2x3.5) that secures the M.2 2230 solid-state drive to the solid-state drive slot on the system board.
4. Slide and remove the M.2 2230 solid-state drive from the M.2 card slot on the system board.
Installing the solid-state drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive assembly and provides a visual representation of the
installation procedure.
16
Removing and installing components