Service Manual
Table Of Contents
- OptiPlex 3000 Thin Client Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 3000 Thin Client
- Side cover
- Speaker
- Solid-state drive assembly
- Memory
- WLAN card
- Optional modules
- Removing the optional Type-C module
- Installing the optional Type-C module
- Removing the optional HDMI module
- Installing the optional HDMI module
- Removing the optional Serial module
- Installing the optional Serial module
- Removing the optional PS/2 keyboard/mouse module
- Installing the optional PS/2 keyboard/mouse module
- Coin-cell battery
- Heat sink
- Antenna Assembly
- SMA Antenna Assembly
- System board
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Align and place the Type-C module into the optional I/O module slot from the inside of the computer chassis.
3. Connect the Type-C cable to the connector on the system board.
4. Connect the DP cable to the video cable connector on the system board.
5. Replace the two (M3x3) screws to secure the Type-C module to the computer chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing the optional HDMI module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following image indicates the location of the optional HDMI module and provides a visual representation of the removal
procedure.
NOTE: Optional VGA and DisplayPort modules have similar procedure as optional HDMI module.
Removing and installing components 23