Service Manual
Table Of Contents
- OptiPlex 3000 Thin Client Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 3000 Thin Client
- Side cover
- Speaker
- Solid-state drive assembly
- Memory
- WLAN card
- Optional modules
- Removing the optional Type-C module
- Installing the optional Type-C module
- Removing the optional HDMI module
- Installing the optional HDMI module
- Removing the optional Serial module
- Installing the optional Serial module
- Removing the optional PS/2 keyboard/mouse module
- Installing the optional PS/2 keyboard/mouse module
- Coin-cell battery
- Heat sink
- Antenna Assembly
- SMA Antenna Assembly
- System board
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Unroute the black antenna-cable from the routing guides under the EMI shielding and from the cable clip.
2. Remove the screw (M3x3) that secures the internal antenna assembly to the system.
3. Lift and remove the internal antenna assembly from the system.
Installing the antenna (Location 1)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of an internal antenna and provides a visual representation of the removal procedure.
32
Removing and installing components