Service Manual
Table Of Contents
- OptiPlex 3000 Thin Client Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of OptiPlex 3000 Thin Client
- Side cover
- Speaker
- Solid-state drive assembly
- Memory
- WLAN card
- Optional modules
- Removing the optional Type-C module
- Installing the optional Type-C module
- Removing the optional HDMI module
- Installing the optional HDMI module
- Removing the optional Serial module
- Installing the optional Serial module
- Removing the optional PS/2 keyboard/mouse module
- Installing the optional PS/2 keyboard/mouse module
- Coin-cell battery
- Heat sink
- Antenna Assembly
- SMA Antenna Assembly
- System board
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Table 6. System setup options—Integrated Devices menu (continued)
Integrated Devices
By default, all options are enabled.
Rear USB ports Enable or disable the individual rear USB ports.
By default, all options are enabled.
Table 7. System setup options—Storage menu
Storage
SATA/NVMe Operation Enable or disable the operating mode of the integrated SATA hard drive
controller.
By default, AHCI/NVMe option is enabled.
Storage Interface
Port Enablement Enable or disable the onboard drives.
By default, all the options are enabled.
SMART Reporting
Enable SMART Reporting Enable or disable Self-Monitoring, Analysis, and Reporting Technology
(SMART) during computer startup.
By default, the Enable SMART Reporting option is not enabled.
Drive Information
M.2 PCIe SSD
Type Displays the M.2 PCIe SSD type information of the computer.
Device Displays the M.2 PCIe SSD device information of the computer.
Onboard eMMC
Type Displays the eMMC type information of the computer.
Device Displays the eMMC device information of the computer.
Table 8. System setup options—Display menu
Display
Primary Display
Video Primary Display Determines the primary display when multiple controllers are available on the
computer.
By default, the Auto option is enabled.
Table 9. System setup options—Connection menu
Connection
Network Controller Configuration
Integrated NIC Controls the on-board LAN controller.
By default, the Enabled with PXE option is enabled.
Wireless Device Enable
WLAN Enable or disable the internal WLAN device
By default, the option enabled.
Bluetooth Enable or disable the internal Bluetooth device
By default, the option enabled.
48 BIOS setup