Laptop User Manual


1. Follow the procedures in "Before You Begin."

2. Remove the keyboard.

3. Remove the metal shield:
a. Loosen the captive metal-shield screws.
b. Lift the shield on the side near the screw holes, slide the shield tabs out from under the edge of the computer base, and lay the shield aside.

4. If a modem is not already installed, go to step 5. If you are replacing a modem, remove the existing modem:
a. Remove the screw that secures the modem to the system board, and set the screw aside.
b. Pull straight up on the attached pull-tab to lift the modem out of the modem connector on the system board, and disconnect the modem cable.

5. Connect the modem cable to the new modem.

6. Align the modem with the modem-screw hole and press the modem into the modem connector on the system board.

7. Install the modem screw to secure the modem to the system board.

8. Replace the metal shield.

9. Replace the keyboard.
1
modem screw
2
modem
3
modem connector on system board
4
modem cable
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.