User's Manual

164 Adding and Replacing Parts

NOTICE: To prevent damage to the connector, do not use tools to spread the

securing clips.

If a WLAN card is not already installed, go to step 5. If you are replacing a

WLAN card, remove the existing card:

Disconnect the WLAN card from any attached cables.

Use your fingertips to carefully spread apart the metal securing tabs

until the card pops up slightly.

Slide and lift the WLAN card out of its connector.

NOTICE: The connectors are keyed to ensure correct insertion. If you feel

resistance, check the connectors and realign the card.

NOTE: Do not insert a Mobile Broadband card into the WLAN card slot.

NOTE: The WLAN card may have two or three connectors, depending on the type

of card you ordered.

1 WLAN card 2 antenna cables (2)