Service Manual
Table Of Contents
- Latitude 3420 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- MicroSD-card
- SIM card tray
- Base cover
- Battery cable
- Battery
- Memory module
- M.2 solid-state drive thermal plate
- M.2 solid-state drive conversion bracket
- M.2 solid-state drive
- Hard-disk drive
- WLAN card
- WWAN card
- I/O cable
- Display assembly
- System fan
- Heatsink assembly
- Power adapter port
- Coin-cell battery
- USB cable
- Ethernet port
- I/O board
- Power-button board
- System board
- Speakers
- Touchpad
- WWAN I/O board
- Palmrest assembly
- Display bezel
- Display panel
- Camera
- Display cable
- Display back-cover
- Drivers and downloads
- System setup
- Troubleshooting
- Built-in self-test (BIST)
- LCD Built-in Self Test (BIST)
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Diagnostic LED behavior
- Diagnostic error messages
- System error messages
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Flashing the BIOS
- Backup media and recovery options
- WiFi power cycle
- Flea power release
- Getting help and contacting Dell
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Remove the SIM card tray for 4G LTE enabled systems.
4. Enter the service mode.
5. Remove the base cover.
6. Remove the I/O board.
7. Remove the ethernet port.
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
NOTE: The following images are from systems shipped with integrated graphic card. The system board has a different
configuration for discrete graphic cards.
Steps
Lift the power-button board off the palmrest assembly.
Installing the power-button board
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
NOTE:
The following images are from systems shipped with integrated graphic card. The system board has a different
configuration for discrete graphic cards.
Removing and installing components 65