Setup Guide

30 Storage Center System Setup Guide
Setting Up the Storage Center
Figure 23. Edit Fault Domains (iSCSI)
2 Select a domain.
3 Click Edit Fault Domain again. The Fault Domain Properties - Domain <num> dialog
appears. From this dialog you can rename the fault domain and add any optional notes.
Figure 24. Fault Domain Properties (iSCSI)
4 Click OK to confirm your changes. The configuration is automatically validated.
5 If there are no warnings, click Continue to proceed with setup by going to Step 13:
Generate SSL Certificate on page 43. If there are warnings, click Configure Local
Ports to modify the configuration and correct any issues that cause warnings. Refer to
Configuring Legacy Mode Local Ports – iSCSI, FC, and SAS on page 28.
 To create a new fault domain
1 Click Create Fault Domain. The Create Fault Domain dialog appears.