Dell Interactive Projector S520 Screen/Whiteboard PTDRV
Important Safety Instructions WARNING: Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided.
Product Dimensions 14.02 in. (356.2 mm) 5.02 in. (127.4 mm) Front View Side View 4.99 in. (126.7 mm) 78.75 in. (2000.1 mm) 80.37 in. (2041.4 mm) 41.60 in. (1056.5 mm) 4.99 in. (984.8 mm) 15.23 in. (386.8 mm) 6.6 in. (167.52 mm) 1.21 in. (30.65 mm) 55.52 in. (1410.1 mm) Back View 1.67 in. (42.3 mm) 2.4 in. (60.9 mm) Top View 28.07 in. (712.
Tools Required for Installation 1/8 in. (wood) 1/2 in.
Installation 1. Determine desired height of image (measured from floor) (Figure 1). 4. Determine location of studs behind drywall. 2. Determine desired center of image area (Figure 1). 5. Drill one pilot hole into a wall stud at location marked in Step 3 (Figure 1). 3. Measure 4-1/16” up from desired height (top) of image and 4” to the right of center of screen and mark location (Figure 1). 4 in. 4-1/16 in. Center of Screen 46-1/8 in. Height from Floor 73-3/4 in.
Installation (continued) 6. Install (1) 1/4” x 1-1/2” bolt and (1) washer through middle of bracket into previously drilled hole, leaving 1/2” of the bolt extending from wall. Use carpenter’s level to make sure bracket is properly level (Figure 2). Previously Drilled Hole Middle Fastener Figure 2 7. Position level on top of wall bracket. Move bracket until level. Drill (2) holes for the other bolts in wall studs. Center of Screen 8.
13. Mount screen onto wall bracket by hooking into the back groove of the screen frame (Figure 6). 14. Secure bottom of screen to wall using (3) of the supplied #8 x 1/2” screws through bottom brackets into the lower channel of the screen frame (Figure 7). 15. Secure marker tray to right side of screen frame at desired height by using (2) of the supplied #8 x 1/2” screws into the side channel of the screen frame (Figure 8). 16.
Installation (continued) 17. Attach sensor cover by snapping clips over screen frame. Secure to frame by screwing down into the upper channel of the screen frame with supplied #8 x 3/4” screw (Figure 10). 18. In between the projector mount and the IR sensor cover, cable clips will be mounted to the wall for cable management. Attach clips to the wall using: Wood studs: (4) supplied #8 x 1” screws. Concrete wall or no studs: (4) supplied #8-10 wall anchors and (4) supplied #8 x 1” screws.
Recommended Screen/Whiteboard Markers Recommended Screen/Whiteboard Cleaning This Dell S520 Screen/Whiteboard is a dual-purpose projection screen and whiteboard. The surface of the screen/whiteboard can be used with dry erase markers from a wide variety of manufacturers and brands. Do not use permanent markers with this product. The supplied cleaning cloth can be used to clean marks on the Dell S520 Screen/Whiteboard surface made by everyday dry erase marker usage.
CW88R Rev.