Dell DL1000 Appliance Getting Started Guide Regulatory Model: E10S Series Regulatory Type: E10S003
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. Copyright © 2014 Dell Inc. All rights reserved. This product is protected by U.S. and international copyright and intellectual property laws.
Installation And Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking A Rack System Unpack your system and identify each item. Installing The Rails And System In A Rack Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system. Figure 1.
Figure 2. Using the System Without a Rack Connecting The Keyboard, Mouse, And Monitor (Optional) Figure 3. Connecting Keyboard, Mouse, and Monitor (Optional) Connect the keyboard, mouse, and monitor (optional). The connectors on the back of your system have icons indicating the type of cable to be plugged into each connector. Be sure to tighten the screws (if any) on the monitor's cable connector.
Connecting The Power Cable Figure 4. Connecting the Power Cable Connect the system’s power cable to the system and, if a monitor is used, connect the monitor’s power cable to the monitor. Securing The Power Cable Figure 5. Securing the Power Cable Bend the system power cable and secure the cable in the retention clip. Plug the other end of the power cable into a grounded electrical outlet or a separate power source such as an uninterruptible power supply (UPS) or a power distribution unit (PDU).
Turning On The System Figure 6. Turning on the System Press the power button on the system. The power indicator should light. Installing The Optional Bezel Figure 7. Installing the Optional Bezel Install the bezel (optional). Complete The System Setup Your system comes with the operating system preinstalled. To reinstall an operating system, see the installation and configuration documentation for the operating system.
system’s hard drive. If you do not accept the terms of the agreement, call the customer assistance telephone number. For customers in the United States, call 800-WWW-DELL (800-999-3355). For customers outside the United States, see dell.com/support and select your country or region from the top left of the page. Other Information You May Need WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included within this document or as a separate document.
Power NOTE: Heat dissipation is calculated using the power supply wattage rating. Voltage 100–240 V AC, autoranging, 50/60 Hz, 4.0 A–2.0 A Maximum inrush current 55 A Battery Coin-cell battery 3.0 V CR2032 Lithium coin cell Physical Height 4.24 cm (1.67 inch) Width 43.4 cm (17.09 inch) Depth 39.37 cm (15.5 inch) Maximum configuration weight 7.7 kg (16.97 lb) Empty weight 4.55 kg (10.
Environmental Operating One shock pulse (one pulse each side of the system) of 31 G for 2.6 ms in the operational orientation. Non-operating Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 71 G for up to 2 ms.
Environmental NOTE: Applies to data center and non-data center environments. Gaseous Contamination NOTE: Maximum corrosive contaminant levels measured at ≤50% relative humidity. 10 Copper Coupon Corrosion Rate <300 Å/month per Class G1 as defined by ANSI/ISA71.04-1985. Silver Coupon Corrosion Rate <200 Å/month as defined by AHSRAE TC9.9.