Users Guide
Table Of Contents
- Dell DL4300 Appliance Owner's Manual
- About your Dell DL4300 Appliance
- Documentation matrix
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Front bezel (optional)
- System cover
- Inside the system
- Cooling shroud
- Hard-drive tray assembly
- Removing the hard drive tray
- Installing the hard drive tray
- Removing a hard drive blank from a hard drive carrier
- Installing a hard drive blank into a hard drive carrier
- Removing a hard drive carrier from the hard drive tray
- Installing a hard drive carrier into the hard drive tray
- Removing a hard drive from a hard drive carrier
- Removing the hard drive backplane from the hard drive tray
- Installing the hard drive backplane in the hard drive tray
- Cooling fans
- Cooling-fan assembly
- System memory
- Processors and heat sinks
- PCIe card holder
- Cable retention bracket
- Integrated storage controller card
- Expansion cards and expansion card riser
- Expansion card installation guidelines
- Removing an expansion card from expansion card riser 2 or 3
- Installing an expansion card into the expansion card riser 2 or 3
- Removing an expansion card from the expansion card riser 1
- Installing an expansion card into the expansion card riser 1
- Removing the riser 1 blank
- Installing the riser 1 blank
- Removing expansion card risers
- Installing expansion card risers
- Internal dual SD module (optional)
- Network daughter card
- System battery
- Power supply units
- Hard drives
- Removing a hot swappable hard drive
- Installing a hot swappable hard drive
- Hard drive backplane
- Control panel
- System board
- Trusted Platform Module
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Safety first — for you and your system
- Troubleshooting system startup failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting iDRAC Direct (USB XML configuration)
- Troubleshooting iDRAC Direct (Laptop connection)
- Troubleshooting a serial I/O device
- Troubleshooting a NIC
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting power supply units
- Troubleshooting cooling problems
- Troubleshooting cooling fans
- Troubleshooting system memory
- Troubleshooting an SD card
- Troubleshooting a hard drive
- Troubleshooting a storage controller
- Troubleshooting expansion cards
- Troubleshooting processors
- System messages
- Getting help
Figure 92. Installing the system board
1. release pin 2. system board
3. system board holder
Next steps
1. Install the Trusted Platform Module (TPM). For information about how to install the TPM, see the
Installing the Trusted Platform Module section. For more information on the TPM, see the Trusted
Platform Module section.
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A
replacement TPM plug-in module will be provided for all system board replacements where a
TPM plug-in module was installed.
2. Replace the following:
a. Cable retention bracket
165