Reference Guide

• network --route (Option only available on a Physical DR)
• network --nslookup [options]
• network --traceroute [options]
• network --ping [options]
• network --blink (Option only available on a Physical DR)
• network --enable (Option only available on a Physical DR)
• network --disable (Option only available on a Physical DR)
• network --troubleshoot [options]
• network --tcpdump [options]
• network --iperf_client [options]
• network --iperf_server [options]
• network --help
NOTE: If you specify a command without supplying the expected value or option, you are prompted to provide the
correct value or option.
NOTE: Most network commands require a network --restart command for the changes to occur.
network --show
Description
Displays the current networking configuration for a DR Series system. (Only a Physical DR has sub-options for network –
show.)
Syntax
network --show [--bondif <bond0,bond1,...,bondN>] [--nwif <eth0,eth1,...,ethN>]
[--hosts] [--routes] [--interface <bondN|ethN>]
--bondif Bond interface(s) to show.
--nwif Eth interface(s) to show.
--hosts Show local host.
--routes Show local routes.
--interface Routes for a specific interface.
Result
Device : bond0
Enabled : yes
Link : yes
Boot protocol : dhcp
IP Addr : 10.20.24.55
Netmask : 255.255.252.0
Gateway : 10.20.32.13
MAC Addr : 78:2B:CB:47:D0:08
MTU : 1500
Bonding options : "mode=balance-alb miimon=100 xmit_hash_policy=2"
Slave Interfaces : eth0,eth1,eth2,eth3
eth0 MAC : 78:2B:CB:47:D0:08
eth0 Max Speed : 1000baseT/Full
eth0 Speed : 1000Mb/s
eth0 Duplex : Full
eth1 MAC : 00:50:56:93:5A:02
eth1 Max Speed : 1000baseT/Full
eth1 Speed : 1000Mb/s
eth1 Duplex : Full
eth2 MAC : 00:50:56:93:5A:03
eth2 Max Speed : 1000baseT/Full
37