Administrator Guide

• Click Peer System, press Ctrl, and select the peer systems in the list box to select one or more peer DR Series

systems in the list that you want to display.

NOTE: Only one of the Container Filter options can be active at any one time (they are mutually exclusive).

3. Select the Header check box(es) for the replication statistics categories for which you want to filter and display in

the Replication Statistics summary table:

• Peer Status

• Replication Status

• Time to Sync

• Progress % (percentage)

• Replication Throughput

• Network Throughput

• Network Savings

• Last Sync in Time

• Peer Container

• Peer Status

NOTE: The following five types of replication statistics are enabled by default: Peer Status, Replication

Status, Network Throughput, Network Savings, and Progress %. If you choose more than five types of

statistics (when you select additional check boxes), a horizontal scroll bar appears at the bottom of the

Replication Statistics table. Use this scroll bar to display the columns of additional statistics that may not

display within the main window.

4. Click Apply Filter to display the replication statistics types you selected to filter for your container or other peer DR

Series system choices.

The Replication Statistics summary table displays the replication statistics types you selected in the Replication

Filter pane.

To reset the default settings in the Replication Filter pane, click Reset.

To update the Replication Filter table after making a change, click Apply Filter to display an updated set of

replication statistics.

NOTE: Use the horizontal and vertical scroll bars to navigate through the columns of replication statistics

displayed in the Replication Statistics summary table.

NOTE: You can set up nightly replication statistics notification mails using the alerts --email --

daily_report yes

command. For more information, see the

Dell DR Series Systems Command Line Interface

Guide

at dell.com/support/manuals.

Displaying Replication Statistics Using the CLI

In addition to using the DR Series system GUI to display replication statistics, you can also display statistics for a

specific replication container by using the DR Series system CLI stats --replication --name <container name> command

to view the following replication container statistics categories:

• Container Name (name of the replication container)

• Replication Source Container (name that identifies the data source)

• Replication Source System (IP address or host name of the data source)

• Peer Status (current status of replication peer; for example, paused)

• Replication State (current state of replication relationship; for example, insync)

• Schedule Status (current status in days, hours, minutes, seconds)