CLI Guide

Result

Please enter administrator password:

Please enter administrator's new password:

Please re-enter administrator's new password:

Changed administrator’s password.

system --telnet [--enable | --disable]

Description

Displays the current telnet access status, or you can use the command options to enable or disable telnet access for a

DR Series system.

Syntax

system --telnet

Result

Telnet State : Disabled

NOTE: In this example, the system --telnet command output showed the telnet access status as disabled. The

following example shows the command for enabling telnet access on your DR Series system. To disable telnet

access, use the system --telnet --disable command.

system --telnet --enable

Successfully enabled telnet.

system --datacheck --enable

Enables one or both Data Check scan options that can be used on a DR Series system. The enable option can be set to

all, namespace, or blockmap. You can individually enable namespace or blockmap scan options, or both options using

the all scan option (which means that both the namespace and blockmap scan types will be enabled).

Description

Enables an individual Data Check scan option type (or both scan types) when used in a DR Series system CLI command.

Syntax

system --datacheck [--enable <all | namespace | blockmap>]

Result

Data Check configuration successful: namespace and blockmap scans currently

enabled.

NOTE: This example shows all Data Check scan options enabled. To enable only the namespace or only the

blockmap scan, use those options respectively in the DR Series system CLI command, for example, --enable --

namespace, or --enable --blockmap.

system --datacheck --disable

Disables one or both Data Check scan option types that can be used on a DR Series system. You can individually disable

namespace or blockmap scan options, or both options using the all scan option (which means that both the namespace

and blockmap scan types will be disabled).

Description

Disables an individual Data Check scan option type (or both scan types) when used in a DR Series system CLI command.