White Papers

DR Series Best Practice Guide

1. Set bond0 to 1GB using the following command:

network --factory_reset [--auto_bonding_speed <1G|10G>]

2. Use the following command to view the new configuration:

network --show

Example

administrator@DR1 >

network -- factory_reset –auto_bonding_speed 1G

Warning: This will stop all system operation and will reset the network configuration to

factory settings and will require a system robbon. Existing configuration will be lost.

One or more of these interfaces 'eth0,eth1' are in use by an application.

Factory reset cannot be done while interfaces are in use by an application.

Factory reset will remove all application interface settings.

Password required to proceed. Please enter the administrator password :

administrator@DR1 > System --reboot

Example

administrator@DR1 >

network -- show

Automatic bonding speed: 1G

Device : bond0

Enabled : yes

Link : yes

Boot protocol : dhcp

IP Addr : 10.250.242.173

Netmask : 255.255.252.0

Gateway : 10.250.240.1

MAC Addr : BC:30:5B:F3:22:74

MTU : 9000

Bonding options : "mode=balance-alb miimon=100 xmit_hash_policy=2"

Member Interfaces : eth0,eth1

eth0 MAC : BC:30:5B:F3:22:74

eth0 Max Speed :1000baseT/Full

eth0 Speed :1000Mb/s

eth0 Duplex :Full

eth1 MAC : BC:30:5B:F3:22:75

eth1 Max Speed :1000baseT/Full

eth1 Speed :1000Mb/s

eth1 Duplex :Full