White Papers
Table Of Contents
- 1 Installing and configuring the DR Series system
- 2 Creating a disk-based target device on CA ARCserve
- 3 Creating a new backup job with the DR Series system as the target
- 4 Setting up DR native replication and restore from replication target
- 5 Setting up the DR Series system cleaner
- 6 Monitoring deduplication, compression, and performance
- A Creating a storage device for NFS
20 Setting Up the Dell™ DR Series System as a Backup Target on CA Arcserve | April 2015
4 Setting up DR native replication and restore from
replication target
Note: The example used in this procedure assumes DR1 is the replication source DR Series system and
DR2 is the replication target DR Series system. ‘ARCsource’ is the replication source container, and
‘ARCtarget’ is the replication target container.
4.1 Creating a DR native replication session
1. Create a CIFS container 'ARCsource' on DR1; create a second CIFS container 'ARCtarget' on DR2.
For each of the containers, on the ARCServe server, configure Windows File System Devices within
the same group.