Owners Manual

Referencia relacionada
Instrucciones de seguridad
Installing an expansion card into the expansion card riser 1
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the expansion card riser.
CAUTION: Muchas de las reparaciones solo pueden llevarse a cabo por un técnico de servicio certificado. Solo debe
ejecutar soluciones de problemas y realizar las reparaciones sencillas de acuerdo con la autorización de la
documentación del producto o según lo indicado por el servicio y asistencia en línea o telefónica. Los daños ocasionados
por reparaciones que no estén autorizadas por Dell no están cubiertos por la garantía. Lea y siga las instrucciones de
seguridad que se suministran con el producto.
NOTE: The expansion card riser 1 can be used only when both the processors are installed.
Steps
1. Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Press tab A and rotate the latch clockwise.
3. Press tab B and rotate the latch down.
4. Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion card connector.
5. Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
6. Close the latches of tab A and tab B.
Figure 35. Installing an expansion card into the expansion card riser 1
1.
tab A 2. expansion card riser 1 cage
3. expansion card connector 4. tab B
5. latch 6. expansion card
Next steps
1. Install the expansion card riser.
96
Instalación y extracción de los componentes del sistema