White Papers
Table Of Contents
- 1 Installing and configuring the DR Series system for use with CommVault Simpana
- 2 Configuring CIFS and NFS containers for CommVault Simpana
- 2.1 Creating containers in the DR Series system
- 2.2 Adding the target container(s) to CommVault Simpana
- 2.2 Setting up a single system environment (DR Series system as NFS disk library)
- 2.3 Setting up a replicated system environment
- 2.4 Using the continuous data replicator to replicate client data to a DR Series container
- 3 Configuring VTL for CommVault Simpana
- 4 Setting up the DR Series system cleaner
- 5 Monitoring deduplication, compression, and performance
- A VTL configuration guidelines
- A.1 Managing VTL protocol accounts and credentials
- A.2 VTL default account summary table
- A.3 Managing VTL media and space use
- A.3.1 General performance guidelines for DMA configuration
- A.3.2 Physical space sizing and planning
- A.3.3 Logical VTL geometry and media sizing
- A.3.4 Media retention and grouping
- A.3.5 VTL media count guidelines
- A.3.6 Adding the VTL media to the container
- A.3.7 Updating CommVault to identify newly added VTL media
- A.3.8 Space reclamation
- B Glossary
42 Setting Up the Dell™ DR Series System as a CIFS or VTL Backup Target on CommVault Simpana |
April 2015
4. Open the Server Manager Snap-in and verify that the newly connected devices
show up in the Device Manager. Verify that the STK Library and IBM Ultrium-TD4
Device Drivers are installed.
Note: Refer to the article at: http://catalog.update.microsoft.com/v7/site/home.aspx, for
more information and assistance in acquiring Microsoft Device Drivers, e.g., StorageTeck
Library Drivers.