Administrator Guide
4. In Service Tag, type the Service Tag associated with your system.
注: If you are unsure of the Service Tag associated with your DR Series system, it can be found on the
Support page (click Support in the navigation panel to display the Support Information pane, which displays
the Service Tag).
5. In Administrator Email enter the email address of the administrator of this system.
The Administrator Email that you enter must match the administrator email address configured in the DR Series
system. If you have set security questions, the security questions are displayed.
6. Enter the answers to the configured security questions in Answer 1 and Answer 2.
7. Click Send Now.
An email with a unique code, used to reset the password, is sent only to the configured administrator email
address. The code is valid for only 15 minutes. The password rest code expires after 15 minutes and cannot be
used. You must repeat the password reset procedure to regenerate the code again.
关闭 DR Series 系统
如果需要,可以通过在 System Configuration(系统配置)页面中选择 Shutdown(关闭)来关闭 DR Series 系
统。但在尝试关闭该系统之前,应充分了解此操作对系统操作的影响。
小心: 关闭 DR Series 系统软件所安装在的设备的电源。电源关闭后,只能在物理位置将电源重新打开,否
则必须为
DR Series 系统使用 iDRAC 连接。
要关闭 DR Series 系统,请完成以下操作:
1. 在导航面板中,选择 System Configuration(系统配置)。
此时将显示 System Configuration(系统配置)页面。
2. 在 System Configuration(系统配置)页面选项栏上单击 Shutdown(关闭)。
此时将显示 Shutdown confirmation(关闭确认)对话框。
3. 单击 Shutdown System(关闭系统)以继续关闭系统(或单击 Cancel(取消)返回 System Configuration
(系统配置)页面)。
重新引导 DR Series 系统
如果需要,可以选择 System Configuration(系统配置)页面中的 Reboot(重新引导)选项来重新引导 DR Series
系统。要重新引导系统,请执行以下操作:
1. 在导航面板中,选择 System Configuration(系统配置)。
此时将显示 System Configuration(系统配置)页面。
2. 单击 System Configuration(系统配置)页面选项栏上的 Reboot(重新引导)。
此时将显示 Reboot System(重新引导系统)确认对话框。
3. 单击 Reboot System(重新引导系统)继续重新引导系统(或单击 Cancel(取消)返回 System Configuration
(系统配置)页面)。
重新引导完毕后(完成系统重新引导过程最长可能需要 10 分钟),将显示 System has successfully
rebooted(系统已成功重新引导)对话框。
配置压缩级别设置
对于要通过 DR Series 系统执行备份和重复数据消除的所有传入数据,可配置要用于这些数据的数据压缩。
74