Administrator Guide

– Peer Container – (Peer-Container) Zeigt den Peer-Container in der Replikationsbeziehung an.
– Peer System – (Peer-System) Zeigt die IP-Adresse des Peer-Systems in der Replikationsbeziehung an.
Weitere Informationen finden Sie unter Anzeigen der Seite „Statistics: Replication“ (Statistik: Replikation).
Creating a Replication Schedule
Replication schedules can only be set on individual replication-enabled source containers. To create a Replication
schedule on a replication-enabled source container, complete the following:
ANMERKUNG: If there is no Replication schedule set, but there is pending data that can be replicated, replication
will run when it detects the following: 1) there are no active data ingests, and 2) five minutes of system idle time
have elapsed since the last data file ingest completed.
ANMERKUNG: The Replication Schedule page displays the current DR Series system time zone and current
timestamp (using this format: US/Pacific, Tue Oct 28 14:53:02 2012).
To schedule Replication operations on your system, complete the following:
1. Select Schedules → Replication Schedule.
The Replication Schedule page is displayed.
2. Click to select the replication-enabled source container in the Container drop-down list.
The Replication schedule table is displayed with columns that identify the week day, start time, and stop time.
3. Click Schedule to create a new schedule (or click Edit Schedule to modify an existing Replication schedule).
The Set Replication Schedule page is displayed.
4. Select (or modify) the Start Time and Stop Time setpoint values using the Hour and Minutes pull-down lists to
create a Replication schedule. For an example, see
Daily Replication Schedule Example and Weekly Replication
Schedule Example.
ANMERKUNG: You must set a corresponding Stop Time for every Start Time in each Replication schedule you
set. The DR Series system will not support any Replication schedule that does not contain a Start Time/Stop
Time pair of setpoints (daily or weekly).
5. Click Set Schedule for the system to accept your Replication schedule (or click Cancel to display the Replication
Schedule page).
ANMERKUNG: To reset all of the values in the current Replication schedule, click Reset in the Set Replication
Schedule dialog. To selectively modify values in the current schedule, make your changes to the
corresponding hours and minutes pull-down lists for the Start Time and Stop Time you wish to modify, and
click Set Schedule.
Dell recommends that you do not schedule the running of any Replication operations during the same time period
when Cleaner or ingest operations will be running. Failure to follow this practice will affect the time required to
complete the system operations and/or impact your DR Series system performance.
Daily Replication Schedule Example
The daily Replication schedule example in this topic illustrates the process for setting up a replication schedule that
uses a 24-hour clock (the time keeping convention where time of day is defined on a 24–hour basis). You set or view a
Replication schedule in the Replication Schedule page. For more information, see Creating a Replication Schedule.
ANMERKUNG: Replication schedules can only be set on individual replication-enabled source containers.
106