Administrator Guide
* 암호 확인
자격 증명은 DR Series 시스템에 필요한 자격 증명과 동일해야 합니다. 자세한 내용은 LSU 구성을 참조하십
시오.
4. Next(다음)를 클릭합니다.
구성한 값이 나열된 Storage Server Configuration Summary(스토리지 서버 구성 요약) 페이지가 표시됩니다.
5. Next(다음)를 클릭합니다.
구성한 스토리지 서버 및 해당 자격 증명이 Storage Server Creation Status(스토리지 서버 생성 상태) 페이지
에 표시됩니다.
6. Next(다음), Finish(마침)를 차례로 클릭하여 스토리지 서버 구성 마법사를 닫습니다.
Storage server
servername
successfully created(스토리지 서버(서버 이름) 생성 완료) 페이지가 표시됩니다.
이제 DR Series 시스템에 사용할 수 있도록 NetBackup이 구성되었습니다.
Creating Disk Pools From LSUs
Use the NetBackup graphical user interface (GUI) to configure disk pools from logical storage units (LSUs) on the DR
Series system.
Log in to NetBackup, and complete the following:
1. In the main window of the NetBackup Administrator console, click Configure Disk Pools to launch the Disk Pool
Configuration Wizard.
The Disk Pool Configuration Wizard page is displayed, which is where you define media servers for use in a disk
pool.
2. In the Welcome to the Disk Pool Configuration Wizard page, click Next.
The Disk Pool page is displayed.
3. In Type, select OpenStorage (DELL), and click Next.
The Select Storage Server page is displayed, and contains a list of available storage servers.
4. In the Storage server list, select a server, and click Next.
The Disk Pool Properties page is displayed.
5. Select the LSUs (volumes) to include from the list, and click Next.
The Disk Pool Properties page is displayed.
6. Enter a Disk pool name, and click Next.
The Summary page for the Disk Pool Configuration Wizard is displayed.
7. Verify the disk pool configuration in the Summary page, and click Next to configure the disk pool you created.
The Performing required task page is displayed, with the status being: Configuration completed successfully. You
have several options available at this point:
– Clear the Create a storage unit for the disk pool.
– Click Finish and close the Disk Pool Configuration Wizard.
– Click Next to create the storage unit with this disk pool.
노트: If you create the storage unit using the Disk Pool Configuration Wizard, you can skip the step where you
create storage units using a disk pool.
8. Click Next to continue with creating a storage unit using this wizard.
9. Enter a Storage unit name, and click Next.
The Successfully Completed Disk Pool Configuration page is displayed.
10. Click Finish.
134