Owners Manual

Item Indicator, Button, or

Connector

Icon Description

• To reset iDRAC (if not disabled in F2 iDRAC

setup), press and hold the button for more than

15 seconds.

2 System identification

connector

Connects the optional system status indicator

assembly through the optional cable management

arm.

3 iDRAC7 Enterprise port Dedicated management port.

NOTE: The port is available for use only if the

iDRAC7 Enterprise license is installed on your

system.

4 PCIe expansion card

slots low-profile (3)

Allows you to connect up to three PCI Express

expansion cards.

5 Serial connector Allows you to connect a serial device to the

system.

6 Video connector Allows you to connect a VGA display to the system.

7 USB connectors (2) Allows you to connect USB devices to the system.

The ports are USB 2.0-compliant.

8 Ethernet connectors Four integrated 10/100/1000 Mbps NIC

connectors

Four integrated connectors that include:

• Two 10/100/1000 Mbps NIC connectors

• Two 100 Mbps/1 Gbps/10 Gbps SFP+/

10GBASE-T connectors

9 PCIe expansion card

slots full height (3)

Allows you to connect up to three full-height PCI

Express expansion cards.

10 Power supply (PSU1)

AC 1100 W

11 Power supply (PSU2)

AC 1100 W

12 Hard drives (2) (back) Two hot-swappable 2.5-inch hard drives.

13 vFlash media card slot Allows you to insert a vFlash media card.

NIC Indicator Codes

The following topic describes the NIC indicator codes of the Dell DR6000 system.