Reference Guide

This option is only available on a Physical DR.
Syntax
maintenance --hardware --motherboard_replaced
maintenance --disk [--make_standby [slot num]] [--type <internal | external-<num> |
service tag>] --clear_foreign]
Description
Creates a standby disk for a DR Series system.
Syntax
The --make_standby [slot num] command option changes the state of a physical disk (making disk 3 in this example the
standby). The slot number (0-11) that is defined in the command identifies the physical disk to set as the hot-swap spare.
maintenance --disk --make_standby 3
The --type <internal | external-<num> | service tag>] command option manages the standby disk type (by specifying it as
internal or external, and if external which enclosure number, or by its service tag).
maintenance --disk --type external-1
The --clear_foreign command changes the state of a physical disk. Use this command when inserting a disk from
another appliance, or the disk had been used in a different RAID configuration. After installing, you must enter the
following command at the system prompt:
maintenance --disk --clear_foreign
NOTE: The output of the DR Series system CLI system --show --hardware command lists the current states of the
system disks. One possible state is foreign , which indicates that the --clear_foreign command needs to be run. In
addition, an alert is generated if the DR Series system detects that any of the disks were in a foreign state.
maintenance --remote_access [--show]
Description
The command shows remote access information.
Syntax
maintenance --remote_access --show
Result
Remote Access Device
Device Type : iDRAC7 Enterprise
iDRAC Ports : Present
IPMI Version : 2.0
System GUID : 3157304f-c0b6-4a80-3910-00564cxxxxxx
Number of Possible Active Sessions : 5
Number of Current Active Sessions : 0
Enable IPMI Over LAN : Yes
SOL Enabled : Yes
MAC Address : 78-45-C4-EC-xx-xx
IPv4 Address
IP Address Source : Static
IP Address : 10.250.241.xxx
IP Subnet : 255.255.xxx.x
IP Gateway : 10.250.xxx.x
119