Release Notes

ID Issue Description Workaround/Solution
20763 System configuration screen displays DHCP
although it is set to static.
Corrected in version 3.1.
20762,
20626
While performing recovery using USB, it is not
possible to recover with the payload on the DR
Series system. The payload on the USB is used;
and, if the version on the USB is higher, the
recovery process upgrades the DR Series system.
The recovery process should use the payload on
the DR Series system such that system is restored
to the same version.
Corrected in version 3.1.
Now, the recovery operation
will only use the payload on
the DR Series system. The
reset operation will pick up
the payload on the USB.
20755 Extra entries are displayed in Global View after a
hostname is changed for a managed unit.
Corrected in version 3.1.
20705 Need to enable DR2000v as replication target. Corrected in version 3.1.
20689 Need to handle overwrites of old format
blockmaps remaining after an upgrade to 3.x.
Corrected in version 3.1.
20627 Under certain conditions, “replication is
disconnected” error occurs when running
replication between two systems with no
scheduling.
Corrected in version 3.1.
20565 After direct upgrade from 1.1.0.x or lower to 3.0.x,
replication does not work if the upgrade occurred
before the containers were in sync.
Corrected in version 3.1.
20284 Dell OpenManage Server Administrator contains
a cross-site scripting vulnerability.
Corrected in version 3.1.
Now, port 1311 used by Dell
Open Manager is blocked.
20067,
20036
DR Series system upgrade process may fail due to
an error condition on the server LifeCycle
Controller - Unified Server Configurator.
These packages are optional
in version 3.1, so if they fail to
load it will not stop the unit
from operating.
20064 Incorrect or out of date statistics may be
displayed when replication is stopped or a
connection is disconnected in a cascaded
replication.
Corrected in version 3.1.
19851 CIFS container paths display incorrectly with
advanced networking.
Corrected in version 3.1.
19848 OST installer does not work with NBU 7.6 Corrected in version 3.1.
19791,
19775
The incorrect IP address displays on the system
configuration screen in the GUI.
Corrected in version 3.1.
19762 Add the ability to mount subdirectories. Added in version 3.1.
19756 CLI Online Help shows “RDA” in a few places
where it should show “RDS”
Corrected in version 3.1.
21