Owners Manual

Figure 73. Cabling diagram—3.5 inch (x12) SAS/SATA backplane
1.
hard drive backplane 2. system board
3. backplane signal connector 0 4. backplane signal connector 1
5. integrated storage controller card
Next steps
1. Install the hard drive backplane.
2. Follow the procedure listed in the After working inside your system section.
Related tasks
Before working inside your system
Removing a hot swappable hard drive or SSD
Removing the cooling shroud
Removing the cooling fan assembly
Installing the hard drive backplane
Installing the cooling fan assembly
Installing the cooling shroud
After working inside your system
Related reference
Safety instructions
Installing and removing system components
131