Users Guide

Using the DRAC 5 With Microsoft Active Directory 123

Configuring the DRAC 5 With Standard Schema Active Directory and

RACADM

Using the following commands to configure the DRAC 5 Active Directory Feature with Standard

Schema using the RACADM CLI instead of the Web-based interface.

Open a command prompt and type the following racadm commands:

racadm config -g cfgActiveDirectory -o cfgADEnable 1

racadm config -g cfgActiveDirectory -o cfgADType 2

racadm config -g cfgActiveDirectory -o cfgADRootDomain <

fully

qualified root domain name

racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupName

common name of the role group

racadm config -g cfgStandardSchema -i <index> -o

cfgSSADRoleGroupDomain <

fully qualified domain name

racadm config -g cfgStandardSchema -i <index> -o

cfgSSADRoleGroupPrivilege <Bit Mask Number for specific user

permissions>

racadm sslcertupload -t 0x2 -f <

ADS root CA certificate

racadm sslcertdownload -t 0x1 -f <

RAC SSL certificate

NOTE: For Bit Mask number values, see Table 14-4.

If DHCP is enabled on the DRAC 5 and you want to use the DNS provided by the DHCP server, type

the following racadm commands:

racadm config -g cfgLanNetworking -o cfgDNSServersFromDHCP 1

If DHCP is disabled on the DRAC 5 or you want manually to input your DNS IP address, type the

following racadm commands:

racadm config -g cfgLanNetworking -o cfgDNSServersFromDHCP 0

racadm config -g cfgLanNetworking -o cfgDNSServer1 <

primary DNS IP

address

racadm config -g cfgLanNetworking -o cfgDNSServer2 <

secondary DNS IP

address>