Users Guide

206 RACADM Subcommand Overview
ping
NOTE: To use this command, you must have Execute Diagnostic Commands or Configure DRAC 5 permission.
Table 13-19 describes the ping subcommand.
Synopsis
racadm ping <ipaddress>
Supported Interfaces
• Remote RACADM
• telnet/ssh/serial RACADM
setniccfg
NOTE: To use the setniccfg command, you must have Configure DRAC 5 permission.
Table 13-20 describes the setniccfg subcommand.
NOTE: The terms NIC and Ethernet management port may be used interchangeably.
Synopsis
racadm setniccfg -d
racadm setniccfg -s [<ipAddress> <netmask> <gateway>]
racadm setniccfg -o [<ipAddress> <netmask> <gateway>]
Table 13-19. ping
Subcommand Definition
ping Verifies that the destination IP address is reachable from
the DRAC 5 with the current routing-table contents. A
destination IP address is required. An ICMP echo packet
is sent to the destination IP address based on the current
routing-table contents.
Table 13-20. setniccfg
Subcommand Definition
setniccfg Sets the IP configuration for the controller.