Users Guide

208 RACADM Subcommand Overview
Sample Output
The getniccfg subcommand will display an appropriate error message if the operation is not successful.
Otherwise, on success, the output displayed in the following format:
NIC Enabled = 1
DHCP Enabled = 1
IP Address = 192.168.0.1
Subnet Mask = 255.255.255.0
Gateway = 192.168.0.1
Supported Interfaces
•Local RACADM
• Remote RACADM
• telnet/ssh/serial RACADM
getsvctag
NOTE: To use this command, you must have Log In To DRAC 5 permission.
Table 13-22 describes the getsvctag subcommand.
Synopsis
racadm getsvctag
Description
The getsvctag subcommand displays the service tag of the host system.
Example
Ty p e getsvctag at the command prompt. The output is displayed as follows:
Y76TP0G
The command returns 0 on success and nonzero on errors.
Table 13-22. getsvctag
Subcommand Definition
getsvctag Displays a service tag.