Users Guide

212 RACADM Subcommand Overview
Synopsis
racadm serveraction <action>
Description
The serveraction subcommand enables users to perform power management operations on the host
system. Table 13-28 describes the serveraction power control options.
Output
The serveraction subcommand displays an error message if the requested operation could not be
performed, or a success message if the operation completed successfully.
Supported Interfaces
•Local RACADM
• Remote RACADM
• telnet/ssh/serial RACADM
getraclog
NOTE: To use this command, you must have Log In DRAC 5 permission.
Table 13-29 describes the racadm getraclog command.
Table 13-28. serveraction Subcommand Options
String Definition
<action> Specifies the action. The options for the <action> string are:
• powerdown — Powers down the managed system.
• powerup — Powers up the managed system.
•
powercycle — Issues a power-cycle operation on the managed system. This action is
similar to pressing the power button on the system’s front panel to power down and
then power up the system.
•
powerstatus — Displays the current power status of the server ("ON", or "OFF")
•
hardreset — Performs a reset (reboot) operation on the managed system.
Table 13-29. getraclog
Command Definition
getraclog -i Displays the number of entries in the DRAC 5 log.
getraclog Displays the DRAC 5 log entries.