Users Guide

40 Installing and Setting Up the DRAC 5
d Update the IPMI SOL baud rate.
NOTE: To redirect the serial console over LAN, ensure that the SOL baud rate is identical to your managed
system’s baud rate.
e Click the Baud Rate drop-down menu, select the appropriate baud rate, and click Apply Changes .
f Update the Minimum Required Privilege . This property defines the minimum user privilege that
is required to use the
Serial Over LAN feature.
Click the
Channel Privilege Level Limit drop-down menu, select User , Operator , or
Administrator .
g Click Apply Changes .
4 Configure IPMI Serial.
a In the Configuration tab, click Serial .
b In the Serial Configuration menu, change the IPMI serial connection mode to the appropriate
setting.
Under
IPMI Serial , click the Connection Mode Setting drop-down menu, select the appropriate
mode.
c Set the IPMI Serial baud rate.
Click the
Baud Rate drop-down menu, select the appropriate baud rate, and click Apply Changes .
d Set the Channel Privilege Level Limit.
Click the
Channel Privilege Level Limit drop-down menu, select Administrator , Operator , or
User .
e Click Apply Changes .
f Ensure that the serial MUX is set correctly in the managed system’s BIOS Setup program.
• Restart your system.
• During POST, press <F2> to enter the BIOS Setup program.
• Navigate to
Serial Communication .
•In the
Serial Connection menu, ensure that External Serial Connector is set to Remote
Access Device
.
• Save and exit the BIOS Setup program.
• Restart your system.
If IPMI serial is in terminal mode, you can configure the following additional settings:
• Delete control
• Echo control
• Line edit