Users Guide

Installing and Setting Up the DRAC 5 47
3 Configure your PET policy.
At the command prompt, type the following command and press <Enter>:
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIPAddr -i 1
<IP_address>
where 1 is the PET destination index and <IP_address> is the destination IP address of the system
that receives the platform event alerts.
4 Configure the Community Name string.
At the command prompt, type:
racadm config -g cfgIpmiLan -o cfgIpmiPetCommunityName <Name>
Configuring E-Mail Alerts
Configuring E-mail Alerts Using the Web User Interface
1 Login to the remote system using a supported Web browser. See "Accessing the Web-Based Interface."
2 Ensure that you followed the procedures in "Configuring PEF Using the Web User Interface."
3 Configure your e-mail alert settings.
a In the Alert Management tab, click Email Alert Settings .
b Under SMTP (Email) Server Address settings , configure the SMTP (Email) Server IP address
field with the appropriate information and then click Apply Changes .
4 Configure your e-mail alert destination.
a In the Email Alert Number column, click an e-mail alert number.
b Ensure that the Enable Email Alert checkbox is selected.
c In the Destination Email Address field, type a valid e-mail address.
d In the Email Description field, enter a description (if required).
e Click Apply Changes .
f Click Send Test Email to test the configured e-mail alert (if desired).
NOTE: Your user account must have Test Alerts permission to perform this procedure. See Table 4-8.
g Repeat step a through step e for any remaining e-mail alert settings.
5 Enable global alerts.
a Click Alert Management and select Platform Events .
b Select the Enable Platform Event Filter Alert checkbox.