Users Guide

Configuring and Using the DRAC 5 Command LIne Console 55
Table 3-4 shows a sample file with the new line.
Enabling the DRAC 5 Serial/Telnet/SSH Console
The serial/telnet/ssh console can be enabled locally or remotely.
Enabling the Serial/Telnet/SSH Console Locally
NOTE: You (the current user) must have Configure DRAC 5 permission in order to perform the steps in this section.
To enable the serial/telnet/ssh console from the managed system, type the following local RACADM
commands from a command prompt:
racadm config -g cfgSerial -o cfgSerialConsoleEnable 1
racadm config -g cfgSerial -o cfgSerialTelnetEnable 1
racadm config -g cfgSerial -o cfgSerialSshEnable 1
For detailed information about how to use RACADM, serial/telnet/ssh, and RACADM commands, see
"Using the RACADM Command Line Interface."
Table 3-4. Sample File: /etc/securetty
vc/1
vc/2
vc/3
vc/4
vc/5
vc/6
vc/7
vc/8
vc/9
vc/10
vc/11
tty1
tty2
tty3
tty4
tty5
tty6
tty7
tty8
tty9
tty10
tty11
ttyS1