Users Guide

Configuring the DRAC 5 Using the Web User Interface 89
5 Configure the advanced settings, if required. Otherwise, click the appropriate Serial Over LAN
Configuration
page button to continue (see Table 4-33).
To configure the advanced settings, perform the following steps:
a Click Advanced Settings .
b In the Serial Over LAN Configuration Advanced Settings page, configure the advanced settings
as required. See Table 4-34.
c Click Apply Changes .
d Click the appropriate Serial Over LAN Configuration Advanced Settings page button to
continue. See Table 4-35.
Table 4-32. Serial Over LAN Configuration Page Settings
Setting Description
Enable Serial Over LAN Enables Serial Over LAN. Checked=Enabled; Unchecked=Disabled.
Baud Rate The IPMI data speed. Select 9600 bps, 19.2 kbps, 57.6 kbps, or
115.2 kbps.
Channel Privilege Level
Limit
Sets the IPMI Serial Over LAN minimum user privilege: Administrator,
Operator, or User.
Table 4-33. Serial Over LAN Configuration Page Buttons
Button Description
Print Prints the Serial Over LAN Configuration page.
Refresh Refreshes the Serial Over LAN Configuration page.
Advanced Settings Opens the Serial Over LAN Configuration Advanced Settings page.
Apply Changes Applies the Serial Over LAN Configuration page settings.
Table 4-34. Serial Over LAN Configuration Advanced Settings Page Settings
Setting Description
Character Accumulate
Interval
The amount of time that the BMC will wait before transmitting a partial
SOL character data package. 1-based 5ms increments.
Character Send Threshold The BMC will send an SOL character data package containing the
characters as soon as this number of characters (or greater) has been
accepted. 1-based units.