Owners Manual
3. captive screw (2) 4. touch point (2)
5. NDC 6. back panel slots for Ethernet connectors
Related references
안전 지침 on page 75
Related tasks
시스템 내부 작업을 시작하기 전에 on page 76
Removing expansion card risers on page 110
Installing the network daughter card on page 124
Identifier
GUID-5231339C-BA70-4CA1-B90E-404CF30F30E3
Version 5
Status Released
Installing the network daughter card
CAUTION: 대부분의 수리는 인증받은 서비스 기술자가 수행해야 합니다. 문제 해결이나 간단한 수리에 한해 제품 문서에
승인된 대로 또는 온라인/전화 서비스 및 지원팀이 안내하는 대로 사용자가 직접 처리할 수 있습니다. Dell의 승인을 받지
않은 서비스 작업으로 인한 손상에 대해서는 보상을 받을 수 없습니다. 제품과 함께 제공된 안전 지침을 읽고 따르십시오.
CAUTION: If the GPU card is installed, you cannot install the 10 GbE Network Daughter Card (NDC).
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #1 screwdriver handy.
NOTE: If the 시스템 has three PCIe cards, ensure that you install the PCIe cooling shroud in your 시스템.
1. Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. To ensure that the connector on the card is in contact with the connector on the system board, press the touch point on the
card.
4. Tighten the two captive screws to secure the NDC to the system board.
5. Install the expansion card riser 3.
124
시스템 구성 요소 설치 및 분리