Manualshelf

Owners Manual

ManualsBrandsDell ManualsCompellent (SCDSMS 730
151152153154155156157158159160
Steps
Insert the hard drive blank into the hard drive slot until the release button clicks into place.
Figure 87. Installing a 3.5-inch hard drive blank
a. hard drive blank
Next steps
If applicable, install the front bezel.
Related references
Safety instructions on page 66
Related tasks
Removing the optional front bezel on page 68
Installing the optional front bezel on page 69
Removing a hot swappable hard drive or solid state drive
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If applicable, remove the bezel.
4. If applicable, remove the system cover to remove hot-swappable drives inside your system.
5. Using the management software, prepare the hard drive for removal. If the hard drive is online, the green activity or fault
indicator flashes while the drive is turning off. When the hard drive indicators are off, the hard drive is ready for removal.
For more information, see the documentation for the storage controller.
CAUTION:
To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the
documentation supplied with your operating system.
Steps
1. Press the release button to open the hard drive or SSD carrier release handle.
2. Slide the hard drive or SSD carrier out of the hard drive slot.
CAUTION:
To maintain proper system cooling, all empty hard drive or SSD slots must have hard drive or SSD
blanks installed.
3. If you are not replacing the hard drive or SSD immediately, insert a hard drive or SSD blank in the empty hard drive slot.
152
Installing and removing system components