Owners Manual

CAUTION: To prevent damage to the control panel flex cable, do not to bend the control panel
flex cable after it is inserted into the connector.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Use the hooks on the chassis as guides to align the hard drive backplane.
2. Slide down the hard drive backplane until the release tabs snap into place.
3. Connect the SAS/SATA/SSD data, signal, and power cables to the backplane.
Figure 59. Installing the four 3.5-inch hard drive SAS/SATA backplane
1. guide (2) 2. hard drive/SSD backplane
3. release tab (2) 4. backplane power cable
5. backplane signal cable 6. SAS_A connector on the backplane
7. hard drive/SSD connector (4)
120