Owners Manual

Boot Settings details

The Boot Settings screen details are explained as follows:

Option Description

Boot Mode Enables you to set the boot mode of the system.

CAUTION: Switching the boot mode may prevent the system from booting if

the operating system is not installed in the same boot mode.

If the operating system supports UEFI, you can set this option to UEFI. Setting this

field to BIOS allows compatibility with non-UEFI operating systems. This option is

set to BIOS by default.

NOTE: Setting this field to UEFI disables the BIOS Boot Settings menu. Setting

this field to

BIOS disables the UEFI Boot Settings menu.

Boot Sequence

Retry

Enables or disables the Boot Sequence Retry feature. If this option is set to Enabled

and the system fails to boot, the system reattempts the boot sequence after 30

seconds. This option is set to Enabled by default.

Hard-Disk Failover Specifies the hard drive that is booted in the event of a hard drive failure. The

devices are selected in the Hard-Disk Drive Sequence on the Boot Option Setting

menu. When this option is set to Disabled, only the first hard drive in the list is

attempted to boot. When this option is set to Enabled, all hard drives are attempted

to boot in the order selected in the

Hard-Disk Drive Sequence. This option is not

enabled for UEFI Boot Mode.

Boot Option

Settings

Configures the boot sequence and the boot devices.

BIOS Boot

Settings

Enables or disables BIOS boot options.

NOTE: This option is enabled only if the boot mode is BIOS.

UEFI Boot Settings Enables or disables UEFI Boot options. The Boot options include IPv4 PXE and IPv6

PXE. This option is set to IPv4 by default.

NOTE: This option is enabled only if the boot mode is UEFI.