Owners Manual

Option Description

lower power idle state. This option can only be enabled if the operating system

supports it. It is set to Disabled by default.

Configurable TDP Enables you to reconfigure the processor Thermal Design Power (TDP) levels

during POST based on the power and thermal delivery capabilities of the system.

TDP verifies the maximum heat the cooling system is needed to dissipate. This

option is set to Nominal by default.

NOTE: This option is only available on certain stock keeping units (SKUs) of the

processors.

X2Apic Mode Enables or disables the X2Apic mode.

Number of Cores

per Processor

Controls the number of enabled cores in each processor. This option is set to All

by default.

Processor 64-bit

Support

Specifies if the processor(s) support 64-bit extensions.

Processor Core

Speed

Specifies the maximum core frequency of the processor.

Process Bus Speed Displays the bus speed of the processor.

NOTE: The processor bus speed option displays only when both processors

are installed.

Processor 1

NOTE: Depending on the number of CPUs, there may be up to four

processors listed.

The following settings are displayed for each processor installed in the system:

Option Description

Family-Model-

Stepping

Specifies the family, model, and stepping of the processor

as defined by Intel.

Brand Specifies the brand name.

Level 2 Cache Specifies the total L2 cache.

Level 3 Cache Specifies the total L3 cache.

Number of Cores Specifies the number of cores per processor.