Users Guide
Table Of Contents
- Dell Lifecycle Controller GUI v2.40.40.40 User's Guide
- Introduction
- Using Lifecycle Controller
- Operating system deployment
- Monitor
- Hardware inventory view and export
- About view and export current inventory
- About view and export factory-shipped inventory
- Viewing hardware inventory — current or factory shipped
- Exporting hardware inventory — current or factory shipped
- Viewing or exporting hardware inventory after part replacement
- Viewing or exporting current inventory after resetting Lifecycle Controller
- Lifecycle Controller log
- Firmware update
- Configure
- System control panel access options
- Configuring iDRAC
- Configuring system time and date
- Configuring vFlash SD card
- Configuring RAID
- Configuring RAID using software RAID
- Creating a secure virtual disk on a RAID controller
- Key encryption
- Local key encryption mode
- Breaking mirrored drives
- System setup — Advanced Hardware Configuration
- Collect system inventory on restart
- Configuring local FTP server
- Configuring a local USB drive
- Configuring NFS and CIFS servers
- Conditions while configuring HTTP server
- Maintain
- Easy-to-use system component names
- Using the system setup and boot manager
- Troubleshooting and frequently asked questions
![](/manual/dell/dss-1500/users-guide-english/images/img-58.png)
6. In the Permissions section under Allow column, select Full Control.
Now the selected folder is shared over network and it can be accessed over CIFS protocol by using the
\\<ip address>\share_name folder path.
NOTE: Lifecycle Controller does not support CIFS message signing feature. Therefore, you must disable the Digitally
sign communications (always) option.
Disabling the Digitally sign communications option
To disable the Digitally sign communications (always) option, perform the following tasks:
1. Open Control Panel and select Administrative Tools.
2. Click Local Security Policy.
3. On the left navigation pane, expand the Local Policies option and select Security Options.
4. Double-click the Microsoft network server: Digitally sign communications (always) option.
5. Select Disabled and click OK.
Conditions while configuring HTTP server
While configuring the HTTP servers, ensure that:
• The HTTP server is configured to the default port (80). The Lifecycle Controller web interface accesses the web server using
the default port. If the web server is configured to a port other than the default, Lifecycle Controller will not be able to access
the web server.
• The Apache web server is set as the default web server. Using other web servers may result in unexpected behavior or errors.
58