Owners Manual

44
Figure 12. Removing and installing the system cover
1 release latch (4) 2 system cover
3 screw
Installing the system cover
Prerequisites
Ensure that you read the Safety instructions.
Steps
1. Align the slots of the system cover with the tabs on the chassis.
2. Slide back the four release latches until they locks into place.
3. Tighten the screw to secure the system cover.
Next steps
Complete the procedure listed in After working inside your system.
Server sleds
NOTE: A dummy sled will be installed over sled B compartment for the single-node system.
Removing the server sled
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.