Owners Manual

52
Figure 19. Attaching the bracket to the X540 card
1 bracket 2 screw (2)
3 X540 card
2. Insert the card into the riser card until the card is fully seated.
3. Secure the card with the screw.
4. For the dedicated management port card, insert the card into the board-to-board connector on the
system board, and secure the card to the server sled with two screws.
Next steps
1. Install the expansion-card riser module on the system board.
2. Complete the procedure listed in After working inside your system.
Related Links
Removing the expansion-card riser module
Installing the expansion-card riser module
Removing the server sled
Installing the server sled
Installing the supercapacitor
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the Safety instructions.
2. Complete the procedure listed in Before working inside your system.
3. Remove the expansion-card riser module.
4. Remove the expansion card.