Owners Manual

Steps

1. Locate the appropriate memory module socket.

CAUTION: Handle each memory module only by the card edges, making sure not to touch the

middle of the memory module or metallic contacts.

2. If a memory module or a memory module blank is installed in the socket, remove it.

NOTE: Retain the removed memory module blanks for future use.

CAUTION: To prevent damage to the memory module or the memory module socket during

installation, do not bend or ﬂex the memory module; insert both ends of the memory module

simultaneously.

3. Align the edge connector of the memory module with the alignment key of the memory module

socket, and insert the memory module in the socket.

NOTE: The memory module socket has an alignment key that allows you to install the memory

module in the socket in only one orientation.

CAUTION: Do not apply pressure at the center of the memory module; apply pressure at both

ends of the memory module evenly.

4. Press the memory module with your thumbs until the socket levers ﬁrmly click into place.

Figure 24. Installing the memory module

1 memory module 2 alignment key

3 memory module socket ejector (2)

When the memory module is properly seated in the socket, the levers on the memory module socket

align with the levers on the other sockets that have memory modules installed.

5. Repeat steps 3 and 4 of this procedure to install the remaining memory modules.

Next steps

1. Install the cooling shroud.

2. Install the server sled.