Owners Manual

90
Figure 42. Removing and installing the paddle board
1 paddle board 2 screw (2)
Related Links
Removing the server sled
Installing the paddle board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Ensure that you read the Safety instructions.
Steps
1. Install the paddle board into the server sled.
2. Tighten the two screws that secure the paddle board to the server sled.
Next steps
1. Reconnect all cables to the paddle board.
2. Complete the procedure listed in After working inside your system.
Related Links
Installing the server sled
HDD cage and backplane
The DSS 7000 chassis supports 3.5-inch (x90) SAS/SATA backplane.
Removing the HDD cage and backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.