Owners Manual
97
Figure 47. Removing and installing the system board
1 screw (6) 2 system board
3 riser support stando
Related Links
Removing the cooling shroud
Removing a memory module
Removing an expansion card
Removing the expansion-card riser module
Removing a processor
Removing the server sled
Installing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: Do not lift the system board assembly by holding a memory module, processor, or
other components.
1. Ensure that you read the Safety instructions.
2. Unpack the new system board assembly.
Steps
1. Hold the system board by its edges and lower the system board into the chassis.
2. Replace and secure the riser support stando with the hex nut.
3. Tighten the six screws that secure the system board to the server sled.