Owners Manual

Figure 37. Installing the GPU power interposer board
Next steps
1. Install the PCIe switch board module.
2. Install the GPU card.
3. Install the GPU support bracket.
4. Install the system cover.
5. Follow the procedure listed in After working inside your system.
Removing a butterfly module and riser 3 board
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the system cover.
Steps
1. Remove the four screws securing the butterfly module.
2. Disconnect all the cables and release the cable ties.
Remove 3M cable start from the bottom as the cable release latch facing the bottom of the butterfly module.
3. Lift the butterfly module from the system.
64
Installing and removing system components