Owners Manual

System board tray module
Removing the system board tray module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the following:
a. Remove the system cover.
b. Remove the air shroud.
c. Remove the GPU card.
d. Remove the GPU support bracket.
e. Remove the PCIe switch board module.
f. Butterfly module
g. Riser 2 Module
h. Riser 1 module
i. Memory
j. Processor and heat sink
k. Network daughter card
Steps
1. Disconnect all cables from the system board.
2. Before the removing the system board tray module, it should loosen the screw at the red mark position.
Figure 79. Loosen one screw
3. Slide the system board tray to make sure the it's not secured by the T standoff.
4. Lift the system board tray module out of the chassis.
94
Installing and removing system components