Owners Manual

Figure 148. Disconnect the cables
3 Locate the screw securing the CMA to the rear of the chassis and remove it.
4 Gently move back the CMA and pull out the cables from the server board side of the chassis. The cables should now be on the tray
side of the chassis.
5 Remove the CMA screw connected to the rear of the hard drive tray.
6 Disconnect the cables from the SAS expander board and pull them out of the hard drive tray.
7 Remove the CMA from the chassis. Make sure the cable ends do not catch on any components during removal to avoid damaging the
server or the cables.
194
Installing and removing server components