Owners Manual

CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied.
Remove memory module blanks only if you intend to install memory modules in those sockets.
CAUTION: To avoid damage, handle memory modules by the edges at all times.
1 Align the indentation on the memory module with the protrusion on the DIMM slot. Make sure they are aligned to avoid damaging the
socket or the module.
2 Push the memory module rmly into the memory module slot.
NOTE: If you are removing the memory module permanently, install a memory module blank.
The locking latches should automatically close over the edges of the memory module when fully inserted into the slot.
Figure 7. Installing the memory module
1 Complete the procedure listed in After working inside your system.
2 Press F2 to start System Setup, and check the System Memory setting.
The System Memory value should reect the newly installed memory.
If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat Step 2 and Step 3 of this
procedure, checking to ensure that the memory modules are rmly seated in their sockets.
3 Run the system memory test in the system diagnostics.
Processor and heat sink
Use the following procedure when:
• Removing and installing the heat sink
Installing and removing server components
53